Electronics for Touchless Turned Lamp

 I could not find a ready-made kit that includes a small battery pack and a motion sensor to feed an LED strip – and would fit into the base of the foot of the lamp. Let me know if there is one. Here you find information how to built it yourself. 

At least, the electronic parts and soldering kit are not expensive, and soldering is not very difficult to teach yourself – being a crafts person.  Working with low voltage electronics is relatively safe.

🎥 This video explains the components and its soldering.

I use the following components:

  1. Battery box battery holder board for 4 x AAA batteries
  2. HC-SR501 Human Infrared Sensor Module
  3. N3904 TO-92 NPN general purpose transistor
  4. Heat shrink tubing, 2 mm
  5. LED strip DC 5V flexible light lamp, warm white color, 1m
  6. Resistors: 47 ohm, 2K2 ohm
  7. Solder iron kit, brass brush
  8. Electric wire stripper

    Comments are closed.